Vaisala PTU300 Podręcznik Użytkownika Strona 129

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 186
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 128
Chapter 4 ________________________________________________________________ Operation
VAISALA ______________________________________________________________________ 127
ECHO
Use the ECHO command to enable/disable echo of characters received
over the serial line.
ECHO [x]
where
x
= ON/OFF (default = OFF)
When using 2-wire connection, echo must be always disabled.
SMODE
Use the SMODE command to set the default serial interface mode.
SMODE [xxxx]
where
xxxx
= STOP, RUN, POLL or SEND
In STOP mode: measurements output only by command SEND, all
commands can be used
In RUN mode: outputting automatically, only command S can be
used to stop
In POLL mode: measurements output only with command SEND
[addr]
In SEND mode: no commands are needed, a message is automatically
outputted after power-up
When several transmitters are connected to the same line, each
transmitter must be entered an own address in the initial configuration,
and POLL mode must be used.
INTV
Use the INTV command to set the RUN mode output interval.
INTV [n xxx]
where
n
= 1 - 255
xxx
= S, MIN or H
Przeglądanie stron 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 185 186

Komentarze do niniejszej Instrukcji

Brak uwag